Regulatory trackerCoverage and methodology
All findings
United States · Federal: EPA TSCAIn force

Chrysotile asbestos TSCA rule: phased prohibitions with interim workplace exposure limit

U.S. EPA's chrysotile asbestos rule phases out ongoing uses under the Toxic Substances Control Act. Since November 25, 2024, chlor-alkali diaphragm and titanium dioxide sheet gasket operations have had to meet an interim exposure limit of 0.005 f/cc as an 8-hour TWA.

Scope to keep in mind

The interim limit covers only those two uses and sits alongside the OSHA asbestos PEL. A court challenge has been reported, and its status was not confirmed from the court docket.

Legal status
Effective with staged provisions
Source check
Nov 11, 2026
Topic
Asbestos

What changed

Previous requirement

OSHA asbestos PEL 0.1 f/cc 8-hour TWA and excursion limit 1.0 f/cc over 30 minutes continue to apply under OSHA authority; the rule cites them for comparison.

New requirement or current position

40 CFR part 751 subpart G prohibits specified chrysotile asbestos uses on use-specific schedules. Under 751.511, owners and operators of covered uses must keep exposures at or below the interim ECEL of 0.005 f/cc 8-hour TWA, conduct initial and periodic monitoring and keep records (751.515(c)).

Who it affects

  • Chlor-alkali
  • Titanium dioxide production

Dates and milestones

Commencement and compliance dates can differ. Read the conditions beside each date, including any stay or local adoption requirement.

Announcement or publication
Mar 28, 2024
Recorded effective date
May 28, 2024
Nov 25, 2024

Owners and operators processing or commercially using chrysotile asbestos diaphragms in the chlor-alkali industry, and commercially using chrysotile asbestos sheet gaskets in titanium dioxide production

Interim ECEL applies and initial monitoring due no later than this date for owners and operators covered as of May 28, 2024 (751.511(b), (c)(2)). Periodic monitoring frequency depends on results (751.511(c)(3)).

Not established or not applicable

Use-specific prohibition dates

Not catalogued in this record.

Selected exposure values

These values need the scope, limit type and averaging period shown below. A proposed or advisory value is not a binding limit.

Chrysotile asbestos

0.005 f/cc
Averaging period8-hour TWA
Limit typeInterim TSCA ECEL
ScopeOnly chlor-alkali diaphragm processing and commercial use, and commercial use of sheet gaskets in titanium dioxide production, during phase-out (40 CFR 751.511(a))

What this could mean for your IH program

Advisory interpretation: Apply the 0.005 f/cc interim ECEL only to the two covered uses. Keep it separate from the OSHA asbestos PEL. Other chrysotile uses are handled through prohibitions rather than this limit.

Confirm applicability with a qualified practitioner before changing your program.

Questions and qualifications

  • Court status not verified. A Fifth Circuit challenge (reported as No. 24-60193, consolidated) was identified only through non-official discovery sources; EPA's page and Federal Register notices do not describe it. PACER was not accessed and no decision was found. A decision could vacate or remand provisions.
  • No Federal Register action on this rule since the April 2024 correction was found. Asbestos Part 2 (legacy uses, RIN 2070-AL21) is a separate planned proposal.
  • Excursion or other EPA values beyond the interim ECEL were not extracted.

Source evidence

  1. Asbestos Part 1; Chrysotile Asbestos: TSCA final rule

    EPA / Federal Register · 89 FR 21970; Dates; 89 FR 21988 (Unit IV, ECEL); 89 FR 21999 (OSHA PEL comparison); 89 FR 22008 (751.511(a)-(c)); FR Doc. 2024-05972; RIN 2070-AK86

    Effective May 28, 2024. Interim ECEL 0.005 f/cc 8-hour TWA beginning November 25, 2024 for chlor-alkali diaphragms and titanium dioxide sheet gaskets only, with monitoring and recordkeeping. Correction at 89 FR 31655 (April 25, 2024).

  2. Risk Management for Asbestos Part 1: Chrysotile Asbestos

    EPA · Managing Risks; updated October 22, 2026

    Describes the final rule without mention of litigation or reconsideration.

Managing your IH program

Explore how LEAP IH supports industrial hygiene data management and risk assessment.

Explore LEAP IH

See a missing update or a correction? Contact APT with this page and the official source.