Regulatory trackerCoverage and methodology
All findings
Canada · British Columbia: Mines Act workplaces (Health, Safety and Reclamation Code)In force

British Columbia mines code changes extended-shift limit adjustment

British Columbia's mines code changed how exposure limits are adjusted for shifts longer than 8 hours, effective June 22, 2026. The silica limit stays at 0.05 mg/m³ respirable and diesel particulate at 0.1 mg/m³ as elemental carbon, but silica is now adjusted by weekly hours, which gives a looser adjusted limit than the old formula on typical long-shift rotations.

Scope to keep in mind

For 12-hour shifts averaging 42 hours a week, the adjusted silica limit works out to about 0.048 mg/m³, where the old formula gave about 0.033 mg/m³. This is an editorial calculation, and each site's shift length and weekly hours change the result.

Legal status
in force
Source check
Nov 11, 2026
Topic
Extended-shift exposure adjustment, silica and diesel particulate

What changed

Previous requirement

Section 2.1.2 adjusted limits for long shifts by Ceq = (8-hour TWA x 8) / shift length in hours. Section 2.1.1(2) deferred the diesel particulate limit (Table 2-1 item 17) until May 1, 2025.

New requirement or current position

For shifts over 8 hours the manager adjusts the TWA using Table 2-4 categories: category II uses a daily factor Fa = 8/Hd; category III a weekly factor Fa = 40/Hwk; category IV the lower of the two; substances not in Table 2-4 the lower of two formulas that also account for recovery time; categories I-A, I-B and I-C are not adjusted. Respirable alpha-quartz and cristobalite are category III. Diesel particulate is category IV. The spent s. 2.1.1(2) transition clause is repealed.

Who it affects

  • Mining
  • Underground mining
  • Surface mining and quarrying
  • Mineral exploration

Dates and milestones

Commencement and compliance dates can differ. Read the conditions beside each date, including any stay or local adoption requirement.

Announcement or publication
Jun 19, 2026
Recorded effective date
Jun 22, 2026

Selected exposure values

These values need the scope, limit type and averaging period shown below. A proposed or advisory value is not a binding limit.

Crystalline silica, alpha-quartz and cristobalite, respirable

0.05 mg/m3
Averaging period8 hours; adjusted for extended shifts under s. 2.1.2 (category III, weekly factor)
Limit typeTLV-TWA
ScopeBC mines under the HSRC, Table 2-1 item 36; respirable fraction

Diesel particulate matter, as elemental carbon

0.1 mg/m3
Averaging period8 hours; adjusted for extended shifts under s. 2.1.2 (category IV)
Limit typeTLV-TWA
ScopeBC mines under the HSRC, Table 2-1 item 17; applies since May 1, 2025

What this could mean for your IH program

Advisory interpretation: Recalculate adjusted limits for every extended-shift schedule using Table 2-4. For 12-hour shifts on a rotation averaging 42 hours a week (for example 4 days on, 4 off), the silica factor is 40/42, about 0.95, giving an adjusted limit of about 0.048 mg/m3. The old formula gave 8/12, about 0.67, or about 0.033 mg/m3 for the same shifts. The new limit is less strict whenever average weekly hours are below five times the shift length; sites may keep the stricter figure as an internal target.

Confirm applicability with a qualified practitioner before changing your program.

Questions and qualifications

  • The worked silica example is an editorial calculation. It assumes 12-hour shifts averaging 42 hours a week. A schedule averaging more than five shifts a week (over 60 hours for 12-hour shifts) gives a stricter limit than before. Section 2.1.2 sets no cap at 1, so a rotation averaging under 40 hours a week gives a factor above 1; how inspectors treat that was not established.
  • The 2024 Code revision that introduced the diesel particulate limit was not re-read. A trade source's 10-hour basis for diesel particulate conflicts with the Code's TLV-TWA column and is not relied on.
  • Substances not in Tables 2-1 or 2-2 follow the ACGIH TLVs as amended from time to time under s. 2.1.1(1)(b).
  • Mines Code limits differ from WorkSafeBC limits. Do not merge the two jurisdictions.

Source evidence

  1. Order in Council No. 255, 2026

    Government of British Columbia · p. 1 (approved June 19, 2026; effective June 22, 2026); Schedule ss. 6 to 8 (pp. 6 to 7 of 37)

    Repeals s. 2.1.1(2) and replaces s. 2.1.2 with the category method and Table 2-4.

  2. Health, Safety and Reclamation Code for Mines in British Columbia, June 2026

    Government of British Columbia · Part 2, s. 2.1.2; Table 2-1 items 17 and 36; Table 2-4 items 203 (diesel particulate, IV) and 523 (alpha-quartz and cristobalite, III)

    Diesel particulate 0.1 mg/m3 as elemental carbon and respirable alpha-quartz and cristobalite 0.05 mg/m3. Silica is category III; diesel particulate is category IV.

  3. Code Revisions Summary Table, June 2026

    Government of British Columbia · pp. 17 to 18 (s. 2.1.2); p. 56 (s. 2.1.1 row)

    Explains the new extended-shift method and notes s. 2.1.1(2) is repealed because May 1, 2025 has passed.

Managing your IH program

Explore how LEAP IH supports industrial hygiene data management and risk assessment.

Explore LEAP IH

See a missing update or a correction? Contact APT with this page and the official source.